FlySight2 Mount

FlySight 2 Mount for externally mounting this audible GPS on most curved skydiving helmets.

Note: This mount is included in the package with a FlySight 2 so this is if you need a replacement or to have mounts on multiple helmets to switch the FlySight 2 to different helmets.

The mount can be secured to the helmet using the supplied VHB tape, or by inserting supplied screws into the mounting holes. The FlySight 2 slides onto posts at the front of the mount, then rotates down and clicks into place at the back like a ski boot. The FlySight 2 is released by pulling back on the tab, either by hand or using the included tool.

Included in the package with the FlySight 2 mount:

• FlySight 2 mount
• Mounting hardware (both VHB tape and screws are included)

Notes on mount compatibility between the FlySight 1 and FlySight 2:

The FlySight 2 has the same footprint as the FlySight 1, so it is compatible with the FlySight 1 aluminum mounts as well as the Cookie FlySight mount. However, it is not compatible with mounts like the one from Adrenaline Workshop, which enclose the entire unit, as the new case is a little taller on one end than the old one.

The new FlySight 2 Mount is not compatible with FlySight 1 units. The FlySight 2 slides onto posts at the front of the new mount, then rotates down and clicks into place at the back like a ski boot. The FlySight 2 is released by pulling back on the tab, either by hand or using the included tool.

The curve on the bottom of the FlySight 2 mounts is the same as the original FlySight 110/110 mounts, which should fit most helmets. Unfortunately, it was not possible to produce this new mount with several different curvatures, but the manufacturer is looking into 3D printed spacers to adapt the mount for helmets with different shapes.